Description
Scania SDP3 Diagnos & Programmer 3 Version 2.60.1.7
Scania SDP3 2.60.1.7 Scania Diagnos3 & Programmer 2.60.1.7
Release notes.
Scania Diagnos & Programmer 3 Version 2.60.1
Scania Diagnos & Programmer 3 Version 2.60.1
2.60.1
New general features
No major new general features in the issue.
New system-specific features
No major new system-specific features in the issue.
General changes
No major general changes in the issue.
System-specific changes
General changes
No major general changes in the issue.
System-specific changes
FLC3, improved method for dynamic calibration
The improved method for calibrating FLC3 means that the calibration time is now shorter.
The wizard can be found under Electrical system > FLC > FLC3.
After running the Calibrating, the camera, dynamic calibration wizard, the vehicle only needs to be driven the entire distance of 50 km in exceptional cases.
The new method means that, while driving, you check that the value for Dynamic calibration status changes from Not calibrated to Calibrated. This signal is new and now included in the wizard Check the status of the camera calibration.
When the value for Dynamic calibration status changes to Calibrated and the values for dynamic calibration are above 90%, calibration is complete and you can stop the vehicle. This usually occurs at a distance driven of 10-20 km. Depending on the circumstances, a distance driven up to 50 km may be required in exceptional cases.
If dynamic calibration has not been completed within a distance driven of 50 km, a fault code will be generated, and you must redo the calibration.
Corrections
No major corrections in the issue.
Exceptions
No major exceptions in the issue.
The wizard can be found under Electrical system > FLC > FLC3.
After running the Calibrating, the camera, dynamic calibration wizard, the vehicle only needs to be driven the entire distance of 50 km in exceptional cases.
The new method means that, while driving, you check that the value for Dynamic calibration status changes from Not calibrated to Calibrated. This signal is new and now included in the wizard Check the status of the camera calibration.
When the value for Dynamic calibration status changes to Calibrated and the values for dynamic calibration are above 90%, calibration is complete and you can stop the vehicle. This usually occurs at a distance driven of 10-20 km. Depending on the circumstances, a distance driven up to 50 km may be required in exceptional cases.
If dynamic calibration has not been completed within a distance driven of 50 km, a fault code will be generated, and you must redo the calibration.
Corrections
No major corrections in the issue.
Exceptions
No major exceptions in the issue.
