CNH FROM 2 SPOOLS TO 3 SPOOLS LOADER HYDRAULIC CONVERSION FOR 4X1 BUCKET – 2WS – SLA – KIT Installation Instructions (92678064)

Out on a construction site or in a quarry, that loader’s working hard—digging, clamping, backfilling, loading trucks. This manual walks you through converting the loader hydraulics from 2 spools to 3 spools so your 4×1 bucket can actually do what it’s built for. You’ll trace lines, route new hoses, install the extra spool, then bleed and test the system so it doesn’t fight you later. Think of a job where you’re trying to grab debris with the bucket jaw but you’re stuck with limited control—this guide shows you how to add that third function the right way, not by guesswork.

Applications & Use Cases

• Trace existing hydraulic lines and identify which hoses and fittings move to the new 3-spool valve so you don’t cross anything.
• Check clearances and mock up valve and hose routing before you tighten a single fitting.
• Isolate hydraulic circuits, swap components, then bleed and test the system for leaks and lazy functions.
• Verify loader and 4×1 bucket operations, then fine‑tune linkage and control lever alignment so everything feels natural.
• Inspect for chafing points and re-route or clamp hoses so they won’t rub through after a few weeks on site.

FAQ

Q: Is this a PDF I can search on my laptop or phone?

A: It’s typically supplied as a PDF, so you can keyword search steps like “bleed” or “torque” while you’re working.

Q: Can I print just the pages I need for the jobsite?

A: Yes, you can usually print selected pages, stick them in a sleeve, and keep them by the machine without risking your whole manual.

Safety Note

Always dump hydraulic pressure, lock out the machine, and verify every circuit is depressurized before you crack a single line.

CNH FROM 2 SPOOLS TO 3 SPOOLS LOADER HYDRAULIC CONVERSION FOR 4X1 BUCKET – 2WS – SLA – KIT Index:

• SAFETY INFORMATION
  • Basic instructions – Important notice regarding equipment servicing
  • Advice
  • Safety rules
• KIT CONTENT
  • Kit overview
• GENERAL INFORMATION
  • Basic instructions
• PRE-ASSEMBLY
  • PREPARING FOR ASSEMBLY
    • Preparation
• ASSEMBLY
  • Install
    • Two spool to three spool hydraulic conversion kit installation

CNH