CNH SMALL-FRAME TIER 4B FINAL FOOT CONTROLS KIT Installation Instructions

These small-frame CNH machines usually live in the dirt—construction sites, feedlots, landscaping yards—where pedals get caked, linkages wear, and operators swap in and out all day. This installation manual walks you through how to remove the old controls, route the new hardware, set up the foot controls, and verify everything works before you put it back to work. Say you’re adding a foot control kit so your crew can run the loader hands-free on the sticks; this guide helps you trace the existing controls, isolate the right brackets, and align the new pedals so they feel right and respond correctly.

Applications & Use Cases

• Swap from hand controls to foot controls so operators can run the boom and bucket more naturally.
• Trace and remove old linkages, then route and install the new kit without guessing what goes where.
• Check clearances and pedal travel, then test and adjust so the machine responds smoothly.
• Inspect mounting points, verify hardware torque against the reference values, and re-check after a few hours’ use.
• Bleed or reset any affected hydraulic or mechanical controls as required after the kit install.

FAQ

Q: Is this a downloadable manual I can search on my laptop or phone?

A: Yes, it’s typically a PDF, so you can keyword search for steps, diagrams, and torque references.

Q: Can I print just the pages I need to take to the jobsite?

A: Usually yes; most folks print the procedure and diagrams, slip them in a sleeve, and keep the full file on a device.

Safety Note

Always support the machine securely and disable any start-up sources before you get under the cab or near the pedal linkage.

CNH SMALL-FRAME TIER 4B FINAL FOOT CONTROLS KIT Index:

• SAFETY INFORMATION
  • Safety rules
• KIT CONTENT
  • Mechanical control – Kit overview – Foot control
• GENERAL INFORMATION
  • Basic instructions
• PRE-ASSEMBLY
  • PREPARING FOR ASSEMBLY
    • Cab tilting system – Prepare for installation
• ASSEMBLY
  • Kit installation
    • Mechanical control – Service instruction
• POST-ASSEMBLY
  • INSTRUCTIONS
    • Operator protections – Check

CNH