CNH DUAL TILT CYLINDER KIT Installation Instructions (92305535)

These kits usually go on tractors or loaders that live in dirt, gravel, and manure all day, shifting implements and handling pallets or buckets. This manual walks you through how to install, route, and align the dual tilt cylinders and plumbing so they actually work the way they should and don’t fight the rest of your hydraulics. Say you’ve bought a tilt kit for a loader and you’re not sure where to tie into the valve block or how to bleed the new lines—this is the kind of guide that keeps you from guessing and tearing it apart twice.

Applications & Use Cases

• Trace the hydraulic circuit so you can isolate the right supply and return ports before you crack any lines loose.
• Check mounting points and verify clearances so the cylinders don’t bind when you curl all the way back or dump fully.
• Route hoses and clamps properly, then inspect for chafe points so you don’t blow a line the first time you crowd a pile.
• Test the tilt function after install, then adjust and align linkage so both sides move evenly and hold grade.
• Use it to bleed air from the system and re-check for leaks after the machine’s warmed up and under load.

FAQ

Q: Is this a PDF I can search on my laptop or phone?

A: It’s typically a standard PDF, so you can use keyword search to jump to sections like valves, hoses, or bleeding.

Q: Can I print just the pages I need for the shop?

A: Yeah, you can usually print specific sections, which is handy for keeping a greasy copy right at the machine.

Safety Note

Always depressurize and lock out the hydraulic system before you disconnect or crack any lines to avoid high-pressure injection injuries.

CNH DUAL TILT CYLINDER KIT Index:

• KIT CONTENT
  • Kit overview
• PRE-ASSEMBLY
  • PREPARING FOR ASSEMBLY
    • Pre-assembly
• ASSEMBLY
  • Three-point hitch control valve
    • Three-point hitch control valve – Remove
    • Three-point hitch control valve – Install

CNH