Format: PDF (Printable Document)
File Language: English
File Pages: 400
File Size: 37.24 MB (Speed Download Link)
Brand: Case
Model: Farmall 90C, 100C, 110C, 120C Efficient Power Tractor
Part No: 91894810
Date: January 2023
Type of Document: Operator Manual
$ 45
GENERAL INFORMATION
Note to the Owner
Intended use
Electro-Magnetic Compatability (EMC)
Manual scope and required training level
Metric and imperial units abbreviations
Identification plates
Operator’s manual storage on the machine
Machine orientation
Selective catalytic reduction (SCR) system
SAFETY INFORMATION
Safety rules and signal word definitions
Safety rules
Safety rules – Fire extinguisher
Safety rules – Front end loader
Ecology and the environment
Towing the tractor for recovery
Tractor jacking points
Burn prevention
Emergency escape from cab
Wheel chocks
Safety signs
CONTROLS AND INSTRUMENTS
Access to operator’s platform
Operator’s seat
Instructional seat
Forward controls
Left-hand side controls
Right-hand side controls
Exterior controls
Display
Warning and advisory symbols
OPERATING INSTRUCTIONS
Commissioning the unit
Starting the unit
Stopping the unit
Moving the unit
TRANSPORT OPERATIONS
Road transport
Recovery transport
WORKING OPERATIONS
General information
Drive
Rear remote control valves
Mid-mount control valve
Rear Power Take-Off (PTO)
Rear hydraulic lift
Towbar
Tread and fender settings
Rear three-point hitch
Tires and wheels
Ballasting
Power sockets
Four-Wheel Drive (4WD)
Front loader
MAINTENANCE
General information
Maintenance planning
As required
At warning message display
Every 10 hours or daily
After the first 50 hours of operation
Every 50 hours
Every 100 hours
Every 300 hours
Every 600 hours
Every 1200 hours or annually
Every 1200 hours or two years
Every two years
Every 3600 hours or two years
Every 3600 hours or four years
Electrical system
Fuse and relay locations
Storage
CALIBRATION
TROUBLESHOOTING
Fault code resolution
Alarm(s)
Symptom(s)
SPECIFICATIONS
General dimensions
Maximum permitted loads on front and rear axle
Maximum permitted loads on drawbar
Additional equipment attachment points
Speed table for 12 x 12 gearbox
Speed table for 20 x 20 gearbox
Speed table for 24 x 24 gearbox
General specification
Front loader and bucket – General specification
ACCESSORIES
Radio
Single piece ballast
Coolant immersion heater (where fitted)
Front loader and bucket – Localization overview