Dynapac CO6200 VI Compaction Full Schematics Diagrams (Electrical and Hydraulic)

On a CO6200 working daily on asphalt compaction, you’re dealing with heat, vibration, and a lot of wiring and hoses packed into tight spaces. This schematic set is what you use to trace the machine’s electrical and hydraulic systems end-to-end, so you can see how components relate instead of guessing. If, for example, the vibration won’t engage or a drum won’t oscillate, these diagrams let you follow the circuits and lines logically until you find where the signal or oil flow stops.

Applications & Use Cases

• Trace electrical faults from the battery and control panel down to sensors, valves, and actuators to isolate a dead circuit.
• Follow hydraulic lines to verify which valve or manifold controls a specific drum or function before you start disconnecting hoses.
• Plan repairs and retrofits, checking how add-ons or replacements will tie into existing power and hydraulic feeds.
• Verify correct routing after hose or harness replacement, making sure everything is reconnected to the right ports and plugs.
• Support remote troubleshooting, using the diagrams to guide an operator over the phone when you’re not on site.

FAQ

Q: Can I use this on a tablet in the field?

A: Yes, it’s well suited for zooming in on specific circuits or line paths on a tablet or laptop next to the machine.

Q: Is it worth printing parts of it?

A: Many techs print the key pages they use most, laminate them, and keep them in the service truck for quick reference.

Safety Note

Always depressurize hydraulic systems and isolate electrical power before using these diagrams to disconnect or test any components.

Dynapac CO6200 VI Index:

4812120800-RevC_hyd diagram CC4000-6200_gen6_Rev_C_3a5fec12.pdf
4812125700_Electrical Diagram_56c8a47c.pdf
4812131527_Electrical Diagram_1754938b.pdf
From S_N A032899_Rev_D_6f196651.pdf

Dynapac