Komatsu WA500-3 Wheel Loader Index:

Foreword
Safety information .
Introduction
Location Of plates, table to enter serial No. and distributor
SAFETY
General precautions
Precautions during operation
7.1 Before starting engine ………..„ .
7.2 After starting engine .
7.3 Transportation
7.4 Battery’ .
7.5 Towing
Precautions for maintenance
8.1 Before carrying out maintenance
8.2 During maintenance … .
8.3 Tires .
Position for attaching safety labels
OPERATION
IO. General view
10.1 General view Of machine ..
102 General view of controls and gauges ..
11. Explanation Of components
Machine monitor
Switches .
Control levers, pedals
Steering column tilt lever
Cap with
Safety bar
Towing pin
Grease pump
Backup alarm
11.10 Fuse
11.11 Slow blow fuse „
11.12 Storaging place Of this manual ……..„…..
11.13 Taking off

12. Operation .
Check before Starting engine .
Starting engine
Operations and checks after starting
Moving machine off .
Changing gear speed
Changing direction
Turning
Stopping machine
Operation of work equipment
Work possible using wheel loader ………………„..,
Precautions for operation
Adjusting work equipment posture …………….„…………..
Parking machine ……..
Checks after completion of operation
Stopping engine
Check after stopping engine
Locking
Handling the tires .
Removal and installation of the bucket
13. Transportation
13.1 Loading, unloading work .
13.2 Precautions for loading .
13.3 Lifting machine .
13.4 Precautions for transportation ………..„
14. Cold weather operation
14.1 Precautions for low temperature
14.2 Precautions after completion of work
14.3 After cold weather
14.4 Warming-up operation for steering hydraulic circuit in
15. Long-term storage
15.1 Before storage
152 During storage —
15.3 After storage
16. Troubleshooting
When machine runs out Of fuel
Towing the machine
If battery is discharged
Other trouble

MAINTENANCE
17. Guides to maintenance ……„…..
18. Outlines Of service
18.1 Outline Of Oil, fuel, coolant
18.2 Outline Of electric System
19. Wear parts list
20. Use Of fuel, coolant and lubricants according to ambient temperature
21. Standard tightening torques for bolts and nuts
21.1 Introduction of necessary tools …..
21.2 Torque
22. Periodic replacement Of safety critical parts
23. Maintenance schedule Chart
23.1 Maintenance schedule chart
24. Service Procedure
Initial 250 hours service
When required .
Check before starting
Every 50 hours service ………….„……………………
Every 100 hours service
Every 250 hours service …….„.,…
Every 500 hours service
Every 1000 hours service
Every 2000 hours service …
24.10 Every 4000 hours service ……„
SPECIFICATIONS
25. Specifications