Case Farmall 65C, 75C Tractor Index:

GENERAL INFORMATION
Note to the Owner
Introduction
Intended use
Electromagnetic interference (EMC)
International symbols
Identification plates
Machine orientation
Operator’s manual storage
Exhaust Gas Recirculation (EGR) exhaust treatment – Product overview
SAFETY INFORMATION
Safety rules and signal word definitions
Safety rules – General information
Ecology and the environment
Air born noise emission
Towing the tractor for recovery
Tractor jacking points
Burn prevention
Fire and explosion prevention
Access to operator’s platform
Safety signs
CONTROLS AND INSTRUMENTS
ACCESS TO OPERATOR’S PLATFORM
OPERATOR’S SEAT
INSTRUCTOR’S SEAT
FORWARD CONTROLS
LEFT-HAND SIDE CONTROLS
RIGHT-HAND SIDE CONTROLS
Power sockets
Settings and display
OPERATING INSTRUCTIONS
COMMISSIONING THE UNIT
STARTING THE UNIT
STOPPING THE UNIT
MOVING THE UNIT
WORKING OPERATIONS
GENERAL INFORMATION
Cab air filters
Transmission
FOUR WHEEL DRIVE (4WD)
DIFFERENTIAL LOCK
REAR POWER TAKE-OFF (PTO)
REAR REMOTE CONTROL VALVE(S)
REAR HYDRAULIC LIFT
Three-point hitch
Front loader
TOWBAR
WHEELS AND TIRES
Ballasting
MAINTENANCE
GENERAL INFORMATION
MAINTENANCE CHART
As necessary
AT WARNING MESSAGE DISPLAY
Every 10 hours or daily
After the first 50 hours of operation
Every 50 hours
Every 100 hours
Every 300 hours
Every 600 hours
Every 1200 hours or annually
Every 1200 hours or two years
Every two years
Every 3600 hours or four years
Electrical system
STORAGE
TROUBLESHOOTING
FAULT CODE RESOLUTION
ALARM(S)
SPECIFICATIONS
Dimensions and weights
Maximum permitted loads on front and rear axle
Speed table for 8 x 8 gearbox
Speed table for 8 x 8 gearbox with additional reducer (12 x 12)
12 x 12 transmission speed table
Speed table for 12 x 12 gearbox with additional reducer (20 x 20)
General Specifications
Loader specifications
ACCESSORIES
Coolant immersion heater (where fitted)
Fuel cooler – Overview