Case Farmall 80N, 90N, 100N, 110N, 120N Tractor with Cab Index:

GENERAL INFORMATION
Note to the owner
Intended use
Electro-Magnetic Compatibility (EMC)
Manual scope and required training level
Metric and imperial units abbreviations
Identification plates
Approval data plate
Operator’s manual storage
Machine orientation
Component identification
Emissions overview
SAFETY INFORMATION
Safety aspects in accordance with Regulation (EU) 1322/2014 – Annex XXII and subsequent amendments and modifications
Safety rules and signal word definitions
Safety rules
Ecology and the environment
Airborn noise emission
Vibration levels
Emergency escape from cab
Towing the tractor for recovery
Tractor jacking points
Burn prevention
Protection offered by the tractor
Safety signs
Instructional signs
CONTROLS AND INSTRUMENTS
Access to operator’s platform
Operator’s seat
Forward controls
Left-hand side controls
Right-hand side controls
Overhead controls
Exterior controls
Display
OPERATING INSTRUCTIONS
Commissioning the unit
Starting the unit
Stopping the unit
Moving the unit
TRANSPORT OPERATIONS
Road transport
Recovery transport
WORKING OPERATIONS
General information
Transmission
Engine accelerator controls
Engine
Clutch pedal
Brakes
Four-Wheel Drive (4WD)
Differential lock system
Air conditioning
Cab pressurizing system
Remote control valves
Hydraulic power beyond for external services with mechnical-hydraulic remote control valves
Rear Power Take-Off (PTO)
Front Power Take-Off (PTO)
Rear hydraulic lift
Rear three-point hitch
Three-point hitch front
Towbar
Wheels and tires
Track adjustment
Ballasting
Power sockets
Fuel cooler
MAINTENANCE
General information
Maintenance planning
As required
AT WARNING MESSAGE DISPLAY
Every 10 hours or daily
Initial 50 hours
After first 50 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 300 hours
Every 600 hours
EVERY YEAR
Every 1200 hours or annually
Every 1200 hours or two years
EVERY 1800 HOURS OR EVERY 2 YEARS
Every two years
Every 3600 hours or two years
Every 3600 hours or four years
Electrical system
Light adjustments
Fuse and relay locations
Storage
Calibrations
TROUBLESHOOTING
Fault code resolution
Alarm(s)
SPECIFICATIONS
Dimensions and weights
Maximum permitted loads on front and rear axle
Maximum permitted loads on drawbar
Towable mass with rear three point hitch
Additional equipment attachment points – Standard front axle
Additional equipment attachment points – Suspended front axle
Speed table for 16 x 16 gearbox
Speed table for 32×16 gearbox
Speed table 44×16 gearbox
General Specifications
ACCESSORIES
Tool box
Advanced Steering Control activation switch