Case Farmall 90C, 100C, 110C, 120C Tractor Index:

GENERAL INFORMATION
Note to the Owner
Intended use
Electro-Magnetic Compatibility (EMC)
ISOBUS certification
Manual scope and required training level
Metric and imperial units abbreviations
Approval data plate
Identification plates
Operator’s manual storage
Machine orientation
Component identification
Emissions overview
Selective Catalytic Reduction (SCR) exhaust treatment – Overview
International symbols
SAFETY INFORMATION
Safety rules and signal word definitions
Safety regulations
Ecology and the environment
Noise levels
Vibration levels
Towing the tractor for recovery
Tractor jacking points
Burn prevention
Prevention of fire or explosions
Emergency escape from cab
Seat and seat belt
Protection offered by the tractor
Wheel chock
Safety signs
Instructional signs
CONTROLS AND INSTRUMENTS
Access to operator’s platform
Operator’s seat
Instructional seat
Forward controls
Left-hand side controls
Right-hand side controls
Exterior controls
Display
OPERATING INSTRUCTIONS
Commissioning the unit
Starting the unit
Stopping the unit
Moving the unit
TRANSPORT OPERATIONS
Road transport
Recovery transport
WORKING OPERATIONS
General information
Drive
Engine accelerator controls
Engine
Clutch
Brakes
Rear remote control valves
Differential lock system
Air conditioning
Cab air filters
Rear Power Take-Off (PTO)
Front Power Take-Off (PTO)
Rear hydraulic lift
Tires and wheels
Tread and fender settings
Ballasting
Power sockets
MAINTENANCE
General information
Maintenance planning
As required
At warning message display
Every 10 hours or daily
After the first 50 hours of operation
Every 50 hours
Every 100 hours
Every 300 hours
Every 600 hours
Every 1200 hours or annually
Every 1200 hours or two years
Every 1800 hours or every 2 years
Every two years
Every 3600 hours or two years
Every 3600 hours or four years
Electrical system
Fuse and relay locations
Storage
Calibrations
TROUBLESHOOTING
Fault code resolution
Alarm(s)
Symptom(s)
SPECIFICATIONS
Dimensions and weights
Maximum permitted loads on front and rear axle
Speed table for 24 x 24 gearbox
Speed table for 40 x 40 gearbox
Additional equipment attachment points
General Specifications
ACCESSORIES
Monitor bracket – (depending on the monitor on request)
Antenna – Location of components
Adjustment of hydraulic flow
Front-end loader fixation points
FORMS AND DECLARATIONS
Telematics module declaration of conformity