Dynapac CA510D Compaction Full Schematics Diagrams (Electrical and Hydraulic)

On a CA510D, you’re usually working on heavy soil compaction in rough sites—dust, vibration, and a lot of stop‑start work. This schematic set is what I’d open when an electrical or hydraulic function isn’t behaving the way it should and I need to trace the system end‑to‑end. For example, if the drum vibration won’t engage or a travel function is weak on one side, I’ll use these diagrams to follow the power and oil paths, verify signal routes, and isolate whether I’m chasing a bad switch, a broken wire, or a control valve issue.

Applications & Use Cases

• Track electrical faults from the battery and fuses through relays, switches, and harness branches to a specific component.
• Trace hydraulic circuits to see how oil should route through pumps, valves, and actuators before you start cracking lines open.
• Verify correct wiring after replacing harness sections, connectors, or control panels.
• Plan safe test points for voltage, continuity, and pressure checks without guesswork.
• Confirm component relationships when cross‑referencing parts with a catalog or service bulletin.

FAQ

Q: Can I use this on a tablet in the field?

A: Yes, it’s practical on a tablet; you can zoom into small circuit details instead of juggling large paper sheets.

Q: Is it still worth printing parts of it?

A: Many techs print only the key pages for a job, laminate them, and keep them at the machine for oily, low‑light conditions.

Safety Note

Always de‑energize circuits and relieve hydraulic pressure before using these schematics to open, disconnect, or test any component.

Dynapac CA510D Index:

From S_N 10000119x0A000001_Rev_Rev__1ef85bdb.pdf
From S_N 10000119x0A000001_Rev_Rev__7223a53f.pdf
From S_N 79620500_Rev_Rev__1ef85bdb.pdf
From S_N 79620500_Rev_Rev__7223a53f.pdf

Dynapac